Acorny
Thank You & Leaflets Framelits Card
All
images © 1990-2015 Stampin’ Up!®
You
may create this look with any framelit, punch or die and for any
season or reason!
Supplies:
Stamp
Sets: Acorny
Thank You (139718)
Card
Stock & Paper: Very
Vanilla (101650), Watercolor Paper (122959) & Gold Glimmer Paper
(133719)
Ink:
Mossy
Meadow Stampin’ Pad (133645); Ink Refills: Hello Honey (133649),
Blackberry Bliss (133648), Tip Top Taupe (138330), Tangelo Twist
(133652) & Mossy Meadow (133651)
Miscellaneous:
Woodgrain
Textured Impressions Embossing Folder (127821); Bitty Banner
Framelits (129267), Leaflets Framelits (138283), Gold Stampin’
Glitter (133457), Gold 1/8” Ribbon (134583), Gold Sequin Trim
(132983), Multipurpose Liquid Glue (110755); Stampin’ Dimensionals
(104430), spray bottle with water
Measurements:
Very
Vanilla card base: 4-1/4” x 11, scored at 5-1/2”
Gold
Glimmer layer: 3-3/4” x 5”
Very
Vanilla layer to be embossed: 3-1/2” x 4-3/4”
Scraps
of Very Vanilla and Gold Glimmer paper for sentiment
Ribbons:
each about 5-6”
Instructions
(refer to additional photos below):
Using
spray bottle, and in an area that you don’t mind getting wet (I
recommend the kitchen and a silicone cutting board or any surface
that is easily washable), spray both sides of a sheet of watercolor
paper and lay flat on silicone mat.
Without
letting the paper dry too much, drop a single drop of an ink refill
in a few (4-5) random spots on the wet watercolor paper. If the ink
pools into a single spot, lightly (and from a bit above) spritz
again to allow it to flow outwards. Repeat for each color but take
care to not overwater to have all the colors mixing into one. Just
take one step at a time and let the magic happen. Allow to dry
overnight. It should look similar to the image below when wet.
While
paper is drying, stamp sentiment using Mossy Meadow on Very Vanilla
scrap. Cut out with Framelit. Adhere to a scrap of Gold Glimmer
paper then fussy cut (by hand) a border to make a layer.
Using
small Very Vanilla piece, run through Big Shot with Woodgrain
embossing folder.
Adhere
the embossed piece to the Gold Glimmer layer.
Using
Dimensionals, adhere that layer piece to the front of the card.
When
watercolor paper dry, die cut leaves wherever you feel the colors
look best (see image below).
Using
the narrow tip of the Multipurpose Liquid Glue dot or streak the
very edges of a leaf then shake on gold glitter. Gently shake off
excess and allow to dry. Repeat with all leaves (you only need 3 for
this card but you may want to just prep the extras while you’re
all glittery).
Choose
your favorite 3 leaves and fan them out with their stems
overlapping. Tie ribbons around to hold together. Trim excess.
Put
1 dimensional onto the back of each leaf, fan out and adhere to
front of card.
Using
Multipurpose Liquid Glue, adhere sentiment to stem of leaves just
above ribbon.
Wet watercolor paper After paper dries
Here are the products used to create this project:
Product List
Thanks for stopping by,